August 13, 2016

Raspberry Pi garage door opener: Part 6

Today I connected the wiring for door activation from the garage door openers to the new screw terminal keystone jacks in the new wall plate in the garage. I also connected the cat5e to the yellow keystone jack. I then installed the new wall plate (stainless steel) into the new wall box. It looks clean and tidy, and I tested the door activation wiring.

I fabricated the remaining part of the rotary encoder mounts from electrial grade fiberglass angle. Both of the rotary encoders are now mounted.

I terminated the POE connection in my Leviton structured media enclosure in the basement. The jack is a yellow Leviton QuickPort, to identify it as needing POE. I used my Rhino labeler to put a heat shrink label on the cat5e cable before I punched it down on the jack. The jack is in a new Leviton 12-port jack panel that I bought to keep my POE jacks separate from non-POE jacks.

I installed the new POE switch in my rack in the basement. I then assembled a short cat5e patch cable and connected the POE switch to my main switch. I then connected one of the POE ports of the new switch to the new jack that leads to the wall plate in the garage. I connected my Raspberry Pi in the garage with a POE splitter. It works fine.

I drilled two more holes in the enclosure for the Raspberry Pi, and installed cable glands. One is for the wires to activate the garage doors, the other is for the cat5e cable. I haven’t decided how I’m going to connect the door switches yet. I’m leaning toward using a single Neutrik speakON 4-pole connector.

Leave a Reply

© 2020 rfdm blog
All rights reserved